 Posted: Wed Apr 30, 2008 10:16 am Post subject: |
|
| thanks rsfruitbat
I will prob take you up on that. You may wonder "whats the point" but whilst im there i might as well do a proper job and may make a smother throttle pedal, along with lubing up the cable itself |
|
| Posted: Tue Apr 29, 2008 5:02 pm Post subject: |
|
| Bearings should be sealed. If you can see the balls then thats not good. Replaced mine and have the number if you need it.
Circlip shouldnt really be a problem bearing carriers should hold it all in place. If you need some bearing carriers I think I probably have a couple spare. rsfruitbat |
|
| Posted: Tue Apr 29, 2008 11:13 am Post subject: |
|
| any one? | |
| Posted: Sun Apr 27, 2008 12:42 pm Post subject: throttle linkage bar bearings |
|
Hello yet again  as you guessed it my tools are being used and the cobwebs have been dusted off them and after removing my throttle linkage bar I noticed that they are very dry and one circlip is missing. Should I replace these or is it possible to re grease or oil, if so what should I use. |
|