 Posted: Fri Feb 06, 2009 11:47 am Post subject: |
|
| Did you get your tester? | |
| Posted: Thu Feb 05, 2009 11:37 pm Post subject: |
|
| thanks,
i guess everyone is using it lol, all i get is http://eper.fiatforum.com/eper/navi?DRIVE=D&GUI_LANG=3&LANGUAGE=3&COUNTRY=012&DRV=D&searchButton=Go!&KEY=STARTUP |
|
| Posted: Thu Feb 05, 2009 10:09 pm Post subject: |
|
| Al... this is an online version of the ePer Fiat/Lancia/Alfa catalogue :
http://eper.fiatforum.com/ Have you tried using Firefox in Ubuntu lately??? It's ACE Bob |
|
| Posted: Thu Feb 05, 2009 10:00 pm Post subject: |
|
| could someone tell me the part number please, thanks | |
| Posted: Wed Feb 04, 2009 12:13 am Post subject: |
|
| lol
dun, so must be fooked, manual just says that if hunting occurs when connection is removed, then replace. I did try resetting the ecu. Can anyone give a technical explanation on how it works in combo with the ecu controlling the rpm? As mine seems to idle just fine without it connected, thanks. |
|
| Posted: Tue Feb 03, 2009 11:49 pm Post subject: Re: replacing Idle valve |
|||
Yes, remove, replace. |
|||
| Posted: Tue Feb 03, 2009 11:11 pm Post subject: replacing Idle valve |
|
| is it called
Idle actuator control valve Idle control valve Is there any special replacement procedure, as in disconnecting the ECU? I ask this as i have just cleaned mine and noticed that when it was connected but not insitu, it had trouble closing fully when the ignition was turned on, there is a hum/buzzing. I think i may have damaged it as i tried to force it open when lubricationg it.I can get the valve to close with no force but now the car wont idle unless the valve is disconnected. |
|