Matt C Alfasud
Joined: 13 Mar 2003 Posts: 43 Location: Brisbane, Australia
|
Posted: Thu May 01, 2003 2:24 pm Post subject: ok |
|
|
will try to translate
big thing = crown wheel
small wheel = pinion
R = reverse
stick = shaft
synchroniser = baulk ring, which is part of a synchromesh unit
there are 3 main shafts
pinion shaft, which has the driven gear on it and synchro's
Primary shaft or counter shaft, which has the drive gears on it
input shaft or Direct drive shaft, which comes from engine.
and then the Reverse gear shaft, it has a retaining screw located on the outside of the gearbox casing, remove this and the shaft it removed.
You really need correct tools for this job, Pullers, a press, dial gauges, torque wrenchs to set correct end float and preload on bearings or the gearbox will fail!
What do you need to know how to remove?
Matt C _________________ Molto Veloce! |
|